Verify, step 6 of 8
Does the chamber hold, and how would I know?
carrying read-only link
Your machines A gauge gives a total pressure, and the analyser resolves which gases make it up. This step reads both through the abacus.
read read from the base typed entered by hand, outside the base
The machine you laid
Back to the builderReading the machine you laid.
What already answers this
Each line links a page of this site and says what it carries for this step.
- /tools/regime-abacus/ says which gauge is valid at the pressure you are reading
- /tools/rga-abacus/ identifies a peak, or says the mass is ambiguous
- /tools/spectrum-abacus/ carries the full reference: signature, ratio, cracking pattern, decision
- /academy/troubleshooting/ walks the standard failures from their spectrum
What are you watching it with?
Reading the system you laid.
| Port | Gauge, typed | Stub | Wall it adds |
|---|
And at the pressure this machine will reach, does that gauge work
And what would it be reading, against the chamber
| Gauge | Chamber | At the head | Gap |
|---|
And at that temperature, what would a gauge be telling you
Not in the base yet
What this step cannot answer, and why. Every count below is read from the corpus at each build.
- unsourced No gauge accuracy, no calibration interval and no sensitivity factor per gas is carried. The regime abacus says which gauge is VALID at a pressure, and gives no error figure for it.
- unsourced The RGA reference base carries no bibliographic key per mass. Its provenance is per base, in the source drawer of the tool, and no value on that page can be traced to one document.
Your machines
kept in this browser, never sent anywhereNothing here yet. Open an archetype, change one thing, and save it here.